Flyte Canvas Hiking Pack
Ideally suited to the rough-and-tumble of school outdoor education, Duke of Edinburgh programmes, or as your first rucksack. The Flyte Backpack is super-tough, easy to fit and available in 4 sizes to fit users of almost all heights.
- Traditional single compartment top loading pack
- Available in 4 fixed harness lengths
- Australian made, heavy duty 370gsm Canvas
- Dual aluminium stays load directly into hip-belt for excellent load transfer
- Double layer fabric base with Canvas inner and 1000 denier Nylon outer
- Canvas bound seams for greater water resistance
- Large padded hip-belt for comfortable fit around hips
- Large front zippered storage pocket
- Zippered pocket on top of lid
- Pleated canvas bottle pockets with drainage holes
- Side and base compression straps
- Nylon storm throat with draw cord
- Adjustable sternum strap with whistle
- Packs flat for easy fleet storage
- Colour coding on front, back and side for quick size identification
- Capacity: 64-76 Litres
- Weight: 2.35kg (Med)
- Fabric: 370gsm Canvas
BACKPACK FITTING GUIDE
|BACK LENGTH (CM)||35-45||40-50||45-55||50-60|
|BACK LENGTH (INCH)||13.5-17.5||15.5-19.5||17.5-21.5||19.5-23.5|
FINDING YOUR BACK LENGTH
To determine your harness size you will need to know your back length. Measuring your back length is easy with the help of a friend.
Measure from your C7 vertebrae down your spine to the point level with the top of your hipbones, the iliac crest.
The C7 vertebrae is the one that sticks out prominently at the back of your neck when you tilt your head forward.
Once you know your harness size it is important to fit the pack correctly. A correctly fitted pack is essential for load carrying comfort.
- Put the pack on, loosen all of the straps and tighten the hip-belt until firm. The middle of the hip-belt pads should wrap snugly over your hips.
Next, tighten the shoulder straps under your arms, then the stabiliser straps between the tops of the shoulders and the top of the pack frame.
With the hip-belt hugging your hip bones the shoulder straps should wrap comfortably over your shoulders without excess pressure.
If the shoulder straps are too tight on your shoulders or sitting loosely above your shoulders, you will need to adjust the harness back length. This is done by tightening or loosening the webbing strap recessed between the shoulder straps at the top of the harness.
For previous model MotoActive and NovoLite harnesses the back length is adjustment is above the lumbar pad or recessed beside the lumbar pad and behind a hip belt.
The curvature of the stays may also need adjusting. Inside the pack is a flap covering the top of the aluminium stay/s. Pull back the flap, pull out the stay and shape it to fit.
Finally, tighten the stabiliser straps between the hip-belt and the base of the pack.
With light to moderate loads you may not need to use the sternum strap, but for heavy loads the sternum strap will provide extra stability.
The best way to evaluate your harness fitting is to load the pack up with about 12kg and go for a wander. A correctly fitted pack will distribute a majority of the weight comfortably on your hips via the hip-belt, the shoulder straps are largely for stability.